在啟動涼茬機之前,咱們應當先查看機器的電機是否正常,再去啟動設備。在查看時,應一起運用吹風機對電機內的塵埃等污垢雜物清理干凈,還要丈量接線是否合格,假如發現電機出現機械損害或許火花灼痕應當立即進行必要的處理工作。
Before starting the stubble cooler, we should check whether the machine's motor is normal before starting the equipment. When checking, we should use the hair dryer to clean up the dirt and debris in the motor, and also measure whether the wiring is qualified. If we find mechanical damage or spark burning marks in the motor, we should do the necessary treatment immediately.
電機運用前的查看方法
Viewing method before motor operation
1、用壓縮空氣或手動吹風機吹凈電動機內部塵埃、電刷粉末等,污垢雜物。
1. Use compressed air or manual blower to clean the dust and brush powder inside the motor and remove dirt and impurities.
2、撤除與電動機銜接的一切接線,用絕緣電阻表丈量繞組對機座的絕緣電阻。若小于0.5MΩ時,應進行烘干處理,丈量合格后再將撤除的接線恢復。
2. Remove all connections connected with the motor and measure the insulation resistance of the winding to the base with an insulating resistance meter. If it is less than 0.5M, it should be dried and the wiring removed will be restored after the measurement is qualified.
3、查看涼茬機換向器的外表是否光潔,如發現有機械損害或火花灼痕應進行必要的處理。
3. Check whether the exterior of the commutator of the stubble cooler is clean or not. If mechanical damage or spark burns are found, the necessary treatment should be carried out.
4、查看電刷是否嚴重?fù)p壞,刷架的壓力是否恰當,刷架的方位是否坐落標記的方位。
4. Check whether the brush is seriously damaged, whether the pressure of the brush holder is appropriate, and whether the direction of the brush holder is in the direction of the mark.
5、根據涼茬機電動機銘牌查看直流電動機各繞組之間的接線方式是否正確,電動機額定電壓與電源電壓是否相符,電動機的起動設備是否符合要求,是否完好無缺。
5. According to the motor nameplate of the stubble cooler, check whether the connection mode between the windings of the DC motor is correct, whether the rated voltage of the motor is in accordance with the voltage of the power supply, whether the starting equipment of the motor meets the requirements, whether it is intact or not.
The above information is our fully automatic stubble machine sorting and publishing hope to help you with our website is: http://furmei168.cn/!